Civil Lab Tools / Soil Testing / MDD & OMC

Soil Testing

Proctor Compaction — MDD & OMC

Enter the test information and mould details once, then add each compaction point. Results are read at the top of a smooth curve through all measured points.

1. Test information

2. Mould information

Wet soil mass = (Mould + compacted wet soil) − Empty mould mass
Wet density = Wet soil mass ÷ Mould volume
Dry density = Wet density ÷ (1 + moisture content ÷ 100)

3. Compaction test points

Use grams for all masses and cm³ for mould volume. Each point needs one compacted mould specimen and one moisture sample from it.

Enter mould details and a test point to begin.

4. Test results

Test Water added (%) Wet density (g/cm³) Moisture content (%) Dry density (g/cm³) Action
No test points added yet.
Maximum Dry Density (MDD)
—
g/cm³
Optimum Moisture Content (OMC)
—
%
Natural Moisture Content (NMC)
—
%

Results will appear after calculating five valid test points.

5. Compaction curve

Dry density is plotted against moisture content. A smooth curve passes through every measured point (orange dots). MDD and OMC are read at the top of this curve (red dot), which can lie between points, and not simply at the highest measured dry density.

FOR CONTRACTOR

Checked by (MT):

Signature: ______________________________

Date:

FOR ENGINEER

Verified by (ME):

Signature: ______________________________

Date:

Engineering note: The reported MDD and OMC are read at the top of a smooth curve (natural cubic spline) drawn through all measured dry-density/moisture-content points, not at the highest measured dry density. The top is searched only within the measured moisture-content range. Use enough valid points to define the curve, including points on both sides of the peak. Confirm mould calibration, compaction procedure, moisture determination, units and reporting requirements against the project specification and applicable test standard. This tool does not determine acceptance or replace engineering review.