Civil Lab Tools / Soil Testing / Atterberg Limits

Soil Testing

Atterberg Limits — Liquid & Plastic Limit

Enter the four cone-penetration determinations and the two plastic-limit determinations. The liquid limit is read from the linear penetration–moisture relationship at 20 mm; plasticity index, linear shrinkage and shrinkage product update as you type.

1. Test information

2. Liquid limit — cone penetration

Enter four determinations. Moisture content = (wet container − dry container) ÷ (dry container − container) × 100. The chart fits penetration against moisture content and reads the liquid limit at 20 mm.

PropertyDetermination 1Determination 2Determination 3Determination 4

3. Plastic limit

Two determinations are averaged. The same moisture-content formula is used; the container number is recorded with each determination.

PropertyDetermination 1Determination 2

4. Sample preparation, linear shrinkage and shrinkage product

Linear shrinkage = (initial length − oven-dried length) ÷ initial length × 100. Shrinkage product = linear shrinkage × percentage passing 0.425 mm. The Excel sheet takes the 0.075 mm value from the grading sheet for its unlabelled check total; enter it here if you want that check shown.

Sheet check total (LL + PL + % passing 0.075 mm): —

5. Atterberg results

Liquid limit (LL)
—
% at 20 mm
Plastic limit (PL)
—
% average
Plasticity index (PI)
—
LL − PL
Linear shrinkage
—
%
Shrinkage product
—
LS × %<0.425

Enter the cone-penetration and moisture determinations. Results update as you type.

Enter at least two valid determinations to fit the penetration–moisture trend.

6. Penetration–moisture chart

Measured determinations, fitted trend and the 20 mm liquid-limit read-off. The guide shows the liquid limit and plastic limit on the same moisture axis.

PREPARED BY

Name:

Signature: ______________________________

Date:

Assistant Materials Technician

CHECKED BY

Name:

Signature: ______________________________

Date:

Consultant's Materials Technician

VERIFIED BY

Name:

Signature: ______________________________

Date:

Consultant's Materials Engineer

Engineering note: The liquid limit is obtained by linear regression of cone penetration against moisture content and solving at 20 mm; the plastic limit is the mean of the two moisture determinations. Confirm the cone mass, penetration time, drying temperature, sample preparation, number of determinations and acceptance criteria against BS 1377 or the project specification. This tool performs the calculation only and does not replace engineering review.